Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.     

Locally enhanced electric field treatment (LEEFT) for water disinfection

• Nanowire-assisted LEEFT is applied for water disinfection with low voltages. • LEEFT inactivates bacteria by disrupting cell membrane through electroporation. • Multiple electrodes and device configurations have been developed for LEEFT. • The LEEFT is low-cost, highly efficient, and produces no DBPs. • The LEEFT can potentially be applicable for water disinfection at all scales. Water disinfection is a critical step in water and wastewater treatment. The most widely used chlorination suffers from the formation of carcinogenic disinfection by-products (DBPs) while alternative methods (e.g., UV, O₃, and membrane filtration) are limited by microbial regrowth, no residual disinfectant, and high operation cost. Here, a nanowire-enabled disinfection method, locally enhanced electric field treatment (LEEFT), is introduced with advantages of no chemical addition, no DBP formation, low energy consumption, and efficient microbial inactivation. Attributed to the lightning rod effect, the electric field near the tip area of the nanowires on the electrode is significantly enhanced to inactivate microbes, even though a small external voltage (usually<5 V) is applied. In this review, after emphasizing the significance of water disinfection, the theory of the LEEFT is explained. Subsequently, the recent development of the LEEFT technology on electrode materials and device configurations are summarized. The disinfection performance is analyzed, with respect to the operating parameters, universality against different microorganisms, electrode durability, and energy consumption. The studies on the inactivation mechanisms during the LEEFT are also reviewed. Lastly, the challenges and future research of LEEFT disinfection are discussed.     

Fuzzy programming method for multi-objective optimal allocation of sediment resources and the cooperative bargaining: a case study in Weishan irrigation area,China

The optimal allocation of sediment resources needs to balance three objectives including ecological, economic, and social benefits so as to realize sustainable development of sediment resources. This study aims to apply fuzzy programming and bargaining approaches to solve the problem of optimal allocation of sediment resources. Firstly, Pareto-optimal solutions of multi-objective optimization were introduced, and the multi-objective optimal allocation model of sediment resources and fuzzy programming model was constructed. Then, from the perspective of multiplayer cooperation, the optimal allocation model of sediment resources was transformed into a game model by using Nash bargaining, and Nash bargaining solution was obtained as the optimal equilibrium strategy. Finally, the influence of different disagreement utility points and bargaining weights on the results was discussed, and the results of Nash bargaining and fuzzy programming methods were compared and analyzed. Results corroborate that Nash bargaining can achieve the cooperative optimization of multiple objectives with competitive relationship and obtain satisfactory scheme. Disagreement utility points and bargaining weights have a certain impact on the optimization results. The solution of fuzzy programming is close to that of Nash bargaining, which provides different ideas for multi-objective optimization problem.

     

Transformation of hazardous lead into aluminosilicate ceramics: structure evolution and lead leaching

This study investigated crystallization mechanisms for the formation of lead aluminosilicate by sintering lead stabilization with kaolin-based precursors. PbAl2Si2O8 was found to be the only stable lead aluminosilicate in low-PbO system and demonstrates its highly intrinsic resistance to acid attack in leaching test. A three-stage PbAl2Si2O8 formation mechanism was supported by the results of the changing temperature in the system. Amorphization of sintered products was observed in both PbO/kaolinite and PbO/mullite systems at 600–700°C. When the temperature was increased to 750–900°C, the crystallochemical formation of lead aluminosilicates (i.e., Pb4Al4Si3O16, Pb6Al6Si2O21, and PbAl2Si2O8) was observed. Pb4Al4Si3O16 and Pb6Al6Si2O21 were found to be the intermediate phases at 700–900°C. Finally, PbAl2Si2O8 was found to be the only crystallite phase to host Pb at above 950°C. A maximum of 80% and 96.7% Pb can be incorporated into PbAl2Si2O8 in PbO/kaolinite and PbO/mullite systems, respectively, but the final products exhibited different microstructures. To reduce environmental hazard of lead, this strategy demonstrated a preferred mechanism of immobilizing lead into PbAl2Si2O8 structure via kaolin-based precursors.     

以Hartwick准则破解“资源的诅咒”

一些资源禀赋较高的国家或地区,一直以来经济社会发展未充分享受自然资源带来的红利,甚至陷入贫困和动荡,这一现象被称作"资源的诅咒";在我国,也有不少资源型城市在发展过程中由于资源的耗竭而陷入困境。经济学家Hartwick对资源枯竭区域发展进行了深入研究,并提出"Hartwick准则"对这一类区域的发展进行了理论指导。本文对Hartwick准则进行简要介绍,以这一准则在非洲国家博茨瓦纳的钻石开发中的应用进行分析,并依据理论和经验,对我国一些资源型区域的发展提出建议。     

农村变电站生活污水处理现状与探讨

我国大部分变电站位于农村地区,因无接入城市污水管网条件,农村变电站生活污水需就地处理后达标排放。变电站生活污水存在水量少、时变化系数大等特点,现有处理工艺不能正常运行或无法达标排放。本文借鉴农村生活污水处理技术,提出了生物组合法处理对策,可为变电站生活污水处理提供参考。     

大气环境监测全过程质量控制研究

我国经济飞快的发展速度,不但丰富了人们的生活内容、方便了人们的生活,而且还在人们生活中产生了一些负面影响,大气污染问题已经引起了国家政府以及我国民众的一致关注,国家还为此制定并颁布了相关的整顿治理措施,在大气环境治理方面,大气监测是重要手段,本文对大气环境监测全过程质量控制问题展开分析研究。     

Study on the measurement and the changing trend of the energy use of China’s economic sectors: based on cross-region input-output model

Environmental Science and Pollution Research - The consumption of fossil energy is the major cause of environmental pollution. Effectively reducing the fossil energy use has important significance...     

Study on the relationship between the incidence of influenza and climate indicators and the prediction of influenza incidence

In recent 2 years, the incidence of influenza showed a slight upward trend in Guangxi; therefore, some joint actions should be done to help preventing and controlling this disease. The factors analysis of affecting influenza and early prediction of influenza incidence may help policy-making so as to take effective measures to prevent and control influenza. In this study, we used the cross correlation function (CCF) to analyze the effect of climate indicators on influenza incidence, ARIMA and ARIMAX (autoregressive integrated moving average model with exogenous input variables) model methods to do predictive analysis of influenza incidence. The results of CCF analysis showed that climate indicators (PM2.5, PM10, SO₂, CO, NO2, O₃, average temperature, maximum temperature, minimum temperature, average relative humidity, and sunshine duration) had significant effects on the incidence of influenza. People need to take good precautions in the days of severe air pollution and keep warm in cold weather to prevent influenza. We found that the ARIMAX (1,0,1)(0,0,1)₁₂ with NO₂ model has good predictive performance, which can be used to predict the influenza incidence in Guangxi, and the predicted incidence may be useful in developing early warning systems and providing important evidence for influenza control policy-making and public health intervention.

     

Emission characteristics of PM,heavy metals,and dioxins in flue gases from sintering machines with wet and semi-dry flue gas desulfurization systems

Environmental Science and Pollution Research - In iron and steel industry, sintering process releases large amount and different kinds of pollutants. Most sintering plants had applied the dust...